Re: CLUNK !
Posted by R H On 2017/8/1 22:49:11
Hi. H.
Yes the bolt hole has slop. But i tighten it and that held it.
This is that 56 carrib. Convert. I have your shaft. Going to see any mods need to be made. It has the hole thru shaft.
What p.d. me off for the manual lever the guy used 11/32nd nuts. I will change that to 3/8s.
The reverse stop. The guy bent it. Guess that' was his upgrade.
To get shaft out i had to hammer it to sorta straighten it out.
Yes..this is what i got when i started to remove parts to get shaft out.
That wire crimp tool i ground to hold 11/32hd nut..the guy doubled nuted
Dollar store.
I could not find an 11/3nd wrench..or a. Cheap ie to grind...not even h.f.
Attach file:
(187.70 KB)
Yes the bolt hole has slop. But i tighten it and that held it.
This is that 56 carrib. Convert. I have your shaft. Going to see any mods need to be made. It has the hole thru shaft.
What p.d. me off for the manual lever the guy used 11/32nd nuts. I will change that to 3/8s.
The reverse stop. The guy bent it. Guess that' was his upgrade.
To get shaft out i had to hammer it to sorta straighten it out.
Yes..this is what i got when i started to remove parts to get shaft out.
That wire crimp tool i ground to hold 11/32hd nut..the guy doubled nuted
Dollar store.
I could not find an 11/3nd wrench..or a. Cheap ie to grind...not even h.f.
Attach file:
(187.70 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=194570