'55 Clipper Twin Ultramatic - replacing throttle valve seal
Posted by onyerleft On 2019/7/28 17:56:11
I'm replacing the throttle valve seal on my Twin Ultramatic, and trying to avoid pulling the transmission just to change two seals. The car is up on jack stands.
Transmission service manual says to "Tap the inner end of the throttle valve inner lever to push the seal out of the case..." but it's not moving (see photo). I've used bolt loosener and "tapped" the hell out of it with a hammer, but no dice.
Any help appreciated.
Transmission service manual says to "Tap the inner end of the throttle valve inner lever to push the seal out of the case..." but it's not moving (see photo). I've used bolt loosener and "tapped" the hell out of it with a hammer, but no dice.
Any help appreciated.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=213759