Re: V8 Pistons

Posted by HH56 On 2009/2/16 21:57:00

Means it was bored .060 over and the standard 413's installed.

This was after the Egge pistons failed. I have since learned from a few of the engine guys on the forum it was not the way to go because something else-- I believe it is deck height-- is wrong. The consensus is the machinist probably messed up the install of Egge's in the first place and was not doing me any favors with the 413's--but it worked and was about all that could be done at the time other than another set of Egges since even then, Packard pistons were very scarce.