You guys are awesome. After reading the comments about tapping it and the shaft going through the hub, I went out and looked closer. There was enough crud at the top that I didnt notice the shaft was protruding through a little. I cleaned it up, sprayed a little PB Blaster, then with a fairly gentle tap with a hammer of the slightly protruding shaft it popped right off!
Thanks again. I added a couple photos to aid the next person that thinks they have a problem when they really need to clean up the part first to see what they got....
Looking at the inside, i'll just try to make a low profile splice to the 'good' part of the inside wire instead of messing with where the wires attach to coils.
-Bob
Attach file:
(275.39 KB) (240.93 KB) (313.14 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=223836