Re: suspension question...

Posted by HH56 On 2009/4/8 9:40:18

If just one corner low, would drive for a bit and check again. If still low only on that corner then look for excessive friction, bushings in poor condition, or something bent. The suspension does rely on low friction, proper lubrication for the various components. Tech bulletin 55-T1 available on site goes into this. Failed bars are not the norm and as I recall, no one posting here has come across any.

If entire side low, then there are factory different length and aftermarket adjustable links for front load arm to take care of differences.

The spec is on a level surface, the height from floor to bottom of car in area between doors is 10" +/- with 3/8 between sides allowable. The leveler basically only controls front to back differences by moving the rear--although should affect everything equally. Generally when leveler adjusted correctly assuming all else proper, the bottom of fender skirt will split the hexagon in hubcap.