Re: DIY Torsion level control switch conversion
Posted by R H On 2023/5/2 2:23:52
Pain to get off.
Need a long hot plate.
This must be a 2 layer pcb . now to figure out where 87a and 30 are connected.
If this can be made to work.
Without pins fitting no problem.
Might have to replace a part. Knocked insulation off.
Might be a resistor..
Edit.
To cut power to 87a. Easiest is to cut foil .
87a contact is solder blob between d4.d5
Attach file:
20230502_001113_HDR_(1).jpg (247.32 KB) 20230502_001251_(1).jpg (269.83 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=256469