Re: Lower Control Arm Outer Pivot Pin

Posted by TxGoat On 2023/5/8 8:57:34

"I already ordered a new one, but it was just as loose as the old one."

I don't think these parts were ever a very tight fit.

The bushing itself must be a tight fit in the control arm, but the bolt, or pin, has to have some clearance in the bushing to allow for flex in the suspension system.

I would consult the correct shop manual for assembly procedures. Improper assembly could lead to issues with binding of parts or difficulty making alignment adjustments.

Front end techs today may not be aware of how to set up and adjust alignment on these suspension systems.