Re: Torsion Level-another dumb-ass question

Posted by Dads 56 On 2024/1/17 17:00:47

This is what I came up with, as the cost plus shipping(shocking) to Canada was prohibitive. After extensive searches on this site. Credit goes to all the other folks on this site who inspired my setup. Its a pipe hangar from industrial pipe/valve supplier. 3/4" threaded rod, bent flat bar, beveled washer on top against the frame. lots of grease between top nut, washer and beveled washer. Cost was around $37 CDN. they were very kind to me. Locked the lower nut in position with a cotter key. chunk of rubber hose on the bottom bolt so as not to scar the support arm. only lifted it up high enough to release pressure. Replaced my lower A arm this way.

Attach file:

---

  TL holding tool (1).JPG (4,465.92 KB)


  torsion bar holding (1).JPG (3,585.10 KB)