Re: Rear axle help (54-55)
Posted by humanpotatohybrid On 2024/4/6 19:22:28
Quote:
The other side took about 5 good whacks with a 2# dead blow hammer to pop off, which actually still seems too low, but whatever. I'll torque it down properly on reassembly.
Per everyone's advice I am not removing more than one axle at a time.
BigKev wrote:
That's actually scary. That axle nut should have been torqued to around 225ft/lbs.
The other side took about 5 good whacks with a 2# dead blow hammer to pop off, which actually still seems too low, but whatever. I'll torque it down properly on reassembly.
Per everyone's advice I am not removing more than one axle at a time.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=269856