Re: Shifter Stop Improvement for 54-56 Twin Ultramatics
Posted by humanpotatohybrid On 2024/7/4 22:42:28
Just for reference in the dimension department:
The piece is made from 1" wide steel. The angle is bent about ¾" from the front side of the transmission, as shown. The total height is about ⅝". It is intended that you adjust the angle to adjust the stop location.
The factory transmission bolt is sufficient for re-install. The piece should have a countersink on the side
opposite the bolt head, to reduce possible movement.
Attach file:
Screenshot_20240704_233738.jpg (323.68 KB)![225076_66876b982bb73.jpg 1440X1542 px](https://packardinfo.com/xoops/html/uploads/newbb/thumbs/225076_66876b982bb73.jpg)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=273717