Re: Timing setting after replacing tappets ?
Posted by Jack Vines On 2009/11/23 21:52:58
Greetings, Xavier,
1. Did you inspect the camshaft to determine what caused the lifter failure? That everything is quiet now is a good sign.
2. What is the P/N of your distributor? Some distributors require 5 degrees BTDC and some 10 degrees.
3. Verify with a timing light you are getting the vacuum and centrifugal advance as per specification.
thnx, jack vines
thnx jack vines
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=41339