Re: how to get power ant. down

Posted by Cli55er On 2008/1/18 10:23:36

the motor continues to run either up or down when the ant. stops. so the motor is good. the ant. tip itself has a slight curve to it, but it didn't seem to care when i got it to go down the first time. it goes up fine after a certain point.....it will run....then after a few seconds the ant. will go up. the ant. will go down, but after a few seconds the motor runs but the ant. doesn't move. the coiled tubing at the bottom of the motor is fine, no dents or dings or binding, they would have to be internal. i was also not able to save the black plastic stub that sits on top of the fender, it was too brittle and the locking ring would not unscrew, but it fit through the hole in the fender once the black plastic was gone. the ant. has been in the up postition for many years....


should i take the large nut at the bottom of the motor off, or just the screws at the top?

thanks,

Hank