J-6065 Load Arm Holding Tool

Posted by Jed Sheehan On 2010/3/20 17:56:56

Does anyone know of a source for a J-6065 tool? Is anyone reproducing them? Is there a need for them? I've seen Craig's solution using a chain and this method looks like it would work well so maybe there's not a need for them.

I've also seen the bluprints in another section of this forum and it seems as if fabricating new tools would not be very difficult nor very expensive.

If there were a source of new tools would there be any interest in them? Say, if one of the PAC regions took this on as a project would there be a demand for it? Anyone have any thoughts?