Re: Engine Bay detailing on a '56 dual carb car

Posted by HH56 On 2010/11/9 15:51:27

Here are the best I can come up with without taking it off which I was going to do but arm is just not co-operating today. I can't see all of your bracket but it looks like it may be the correct one--coil is just slid in further. One thing I did notice is more philips head screws used on other things. Look at the rest of your car. If you see a lot of philips head, then this may in fact be the correct screw and that is what you need to find. That picture out of service manual with fuzzed center does sort of look like there is an indication it might be philips. That is one the radio noise suppression condensers.

Attach file:

---

  (37.73 KB)


  (23.74 KB)