Re: Torsion level question

Posted by HH56 On 2010/11/22 11:58:27

I don't know if the tools were ever reproduced but they are very simple.. Look at the top of the lower arm to see the spacing between the two upper retainer tabs. That piece is just sheet steel or aluminum approx 1/8 thick -- just thick and wide (maybe 2" or so) enough to fit in the slots behind the tab and has two protruding legs of approx 1/4" long--one into each slot. The other part is a regular C clamp. Large enough to fit as shown in the picture. You can take the fixed end to a grinder and grind a slight groove or contour into it so it won't roll off the upper rounded corner of retainer.

Attach file:

---

  (7.92 KB)


  (20.29 KB)