Re: All wiring nominal and TL not working

Posted by HH56 On 2011/6/12 11:58:47

I guess the difference must be in wheelbase. Looked at mine this morning and the one upper bolt is hard to get to for holding but was able to slip an open end thru from driveshaft side to hold it--granted, mostly by feel. As to the other end, on mine, no problem with a socket to remove them but if your frame is too close, is there a possibility to get one of the ratcheting type combination open/box ends on the motor side and hold it with a regular open end on the other. Loosen and remove the nuts but leave the bolts in housing and slide both bolt and motor/armature off as a unit.

Here's my spacing and also a few poor photos with a wrench in place. Hard to get a decent camera angle. Last photo shows the bolt from the top of a unit.

Attach file:

---

  (32.91 KB)


  (136.58 KB)