Re: All wiring nominal and TL not working
Posted by Robert Freeman On 2011/6/24 7:13:25
Great news...
was able to get the motor loose and manually turn the worm shaft. The rear end lifted and the car is sitting level
The TL motor is at a specialty shop being checked out prior to it's reinstallation. I did notice one thing while turning the worm shaft, it is not held in by anything and will turn its way out of the case. Is this correct?
The 2 link bars are slightly bent and the outer holding screws don't want to come out. Can I drive the car with the existing bent rods?
I need to check out all components of the TL system to find any non-functioning parts. I dodn't want the car to drop and go through this again.
Almost there!
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=80161