Re: 90 degree heater hose fitting problems
Posted by Cli55er On 2012/3/11 12:56:02
when i measure with my calipers the orginal pipe fitting at the arrow that i made in the picture i get 5/8 OD. when i measure the opening of the part that is on the motor it is 5/8.
so it starts at 5/8 and gets bigger to seal up to keep water from coming out.
is this the same as you are measuring? seems like the 1/2 would start at 1/2 and go to 3/4, so 5/8 would be in there before you could thread it all the way in. but 1/2 is too small to start my threading into the head.
maybe i'm confused.
Hank
Attach file:
(11.21 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=96516