Re: ultramatic

Posted by R H On 2012/4/14 14:58:32

green bay,,as far as heat,,i don't think so, that tail shaft is full of oil,

the only thing i am not sure of is that i had to grind the shaft down a few thousands. i am more worried of spliting the shaft. but i think it will be ok,,, ia am not going to race it. do burn outs etc...

what i might do is machine a new casting that holds the bushing. Since its comes out, then i can keep the org. size of shaft.

and get a larger needle bearing. machined to fit.

rik