Re: window channel 56 400

Posted by BH On 2012/8/7 8:32:58

Plate No. 20E in the parts books provides an exploded view of the door window hardware, but that's not enough help. Take a look at Figure 53 in the "Body" section of the 55-56 shop manual, which shows the adjusting points for your door glass.

Support the rear of the window glass, remove the two screws for adjusting the rear channel (retainer), and you'll be able to remove the assembly and work on your bench. Even if it's a spot weld that's broken there should be sufficient evidence where to locate and drill holes.