Re: Twin Ultramatic Problem

Posted by R H On 2012/9/10 0:50:35

Hi, Howard,

Shortly I will be blogging my ultra project, but, I am refering to bell housing bushing. there is a hole right where the seal bottoms out, just in from that. thats a drain hole?, its like 3/16s,,seems to me the spare bell housing i have the bushing extends into that area,,have to look again..,,so if that is blocked, then oil from bushing/shaft, would work out of the seal, cause i know mine leaked .

The needle bearing is R/D,, reducing friction,,,been held up with machine shop...oil pressure?, remains to been seen, the only bushing I cannot replace with needle bearing, is the ft pump, that goes into high range clutch, that will be made alum. bronze, I will be making that, next ultra project, will be to use all alum bronze for bushings..with that chrome hardened the shafts, if the chrome won't mess with valve bodies..

rik