Re: 1956 Brake Light Switch, Where is it?

Posted by 55clipper On 2012/9/17 20:48:27
I have an idea that might work. Use two long threaded rods. Remove the mounting screws one at a time and screw on the threaded rods one at a time from the inside of the car leaving to long shafts extending from the switch holes through the floor board. Push the shafts to move the switch through the oval hole. Replace the wire than pull the rods tight, with the switch inplace. Replace the shafts one at a time. Sounds like it might work.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=109980