Re: ultramatic sprung pin selector rod question

Posted by Cli55er On 2008/6/7 23:45:55

well at least i am not the only one that repaired their's the same way. the hole in mine i believe may have already been there on that one cup....but most likely i did it while tapping them out. dang.....well at least i got it back together and it does work now, but i think i should try to locate a new cup without a hole in it.

jb weld, the company, may know what would happen in hot tranny fluid. i know if sounds kinda jacked up to use it, but it would fill the hole in and hold the piece at the same time ;0)...and i doubt i can just run to the autozone for this part LOL...so i may have to do what i can to make it work. thanks for the great pictures they are way better than my camera phone!