Re: One oil pump modification now on file
Posted by R H On 2013/10/28 23:12:13
randy's ebay car,
well jack answered my question here after re-reading this thread.
the upper was never dealt with. With the pi pump,
i would go with jack for rebuild.
i may go with a one piece shaft. get rid of that sleeve.
but press a piece of stock over shaft to hold shaft up/,, shaft supported all the way up into main bearing cap.
thinking of using stainless for bushing,,and shaft.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=133996