Re: T-L Front upper control arm bushings R&R
Posted by BDeB On 2013/4/20 15:34:11
Quote:
Riki wrote:
with spreader out , its 8 1/16,, gap is 3/8s on each side..going to make spacer to go between washer and bushing..
Looks like your control arm has been spread too far out.
The 8-1/16" measurement should be from the outside of the upper control arm as per Figure 14 on page 5 of the Suspension and Steering section in the 1951 to 54 service manual (1955-56 is the same)
Can't speak for the Raybestos and Moog parts, but Ford D3AZ-3068-A bushings match the original Packard parts.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=121361