Re: Torsion Leveling Problem on '56 Clipper

Posted by Ken Hill On 2013/4/21 19:44:16

Thank you for confirming that there should be power to both small terminals. Both solenoids are also installed correctly with the rounded end on the top.

Since I'm not getting power to the bottom (down) solenoid's small terminal, then I think I will try replacing it. Any suggestions as were to find them?

I replaced them about two years ago, because of a similar problem. I can try that place again, but I thought I'd ask around for other places. The ones I replaced were used; so I suspect they may have outlived their lives.

Thanks again for all of your help.