Re: Torsion Leveling Problem on '56 Clipper

Posted by Let the ride decide On 2013/4/24 22:54:39

When I had to take the motor off the TL gearbox, the armature stayed in place. I then spun it to move the bars the way I needed it to go. It went faster than a screwdriver, but not as fast as putting a screwdriver bit in a drill.

If your TL did rotate the wrong way, you will need to look at the short bars to see if they are bent. You might need to look at the gear box for damage. The limit switches need to be checked too.