what i got from mike, nice grinding,
ok,, so to reuse this, od used 1/4 inch, with no problems, me i would like 3/8's . as long as turned down part is there, that should be just lower than bracket, so when you torque it down your pulling spacer up.
using 3/8's the bolt head will cover the 1/2 inch hole. without a washer. will have to drill into that spacer at least half way for threads.
if i make this up, the end plates will have a 7/16th hole. the plates maybe stainless. drill through the spacer for 7/16 bolt. like i did for mine ,, but without inner washers, think i said why i had to do that.
pat, hope that helps..
Attach file:
(81.63 KB) (77.35 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=125852