Re: 55/56 body mounts/pads

Posted by HH56 On 2013/6/4 10:59:49
Since you have photos, that's a good indication of how the rubber goes. The thing you are trying to do is isolate the body from the frame. One or the other is sandwiched between the rubber. Whether the rubber pieces are between the frame hole and solid to the body or between the body and solid to the frame is not going to affect the isolation too much. Since you have some photos showing some locations, I'd sit the body above the frame and start with known configuration. Once you get a few known installed, the distance you have between the frame and body at others or the relative size of the holes should give an indication of what goes where.

#1 is the firewall locations in engine compt and goes rearward with total depending on your model. The picture in the frame section of SM shows where they are.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=124615