Quote:
In the parts book it is listed under section 30.7925 and part #469670-71 It mention that this part is for the 5588, 5587 and 5582 which is the Patrician. But the patrician is a four door car and therefore the moulding would be a different length. I am not sure what to make of it or am I looking at the wrong part.?
Terminology gets confusing as ALL of the rear fender moldings (below the beltline) are lumped into this one grouping. So, you have to study any additional descriptive text that's provided for each application listing.
Also, the locations are indentifed by relative position, but still a bit confusing. While the 55-56 Carib and 56 400 and Pat have three (3) locations: lower, center, and upper. the 55 400 and Pat have only two (2) locations: lower and upper.
P/N 469670-71 is actually the lower molding that runs aft of the rear wheel opening and is used on 55 AND 56 Carib, 400 and Pat - some call it a gravel shield.
The spear that runs aft of the bottom of the courtesy light is labelled as a
center molding for 55-56 Caribbean and 56 400 (and Pat), but labelled as an
upper on 55 400 (and Pat) because there is no fender molding above it that year. Of course, because the correpsonding molding for the Pat IS shorter, it has a separate application listing with unique P/Ns (RT-LT).
The lower rear fender moulding on the passenger (RT) side for a 55-56 Carib is, therefore, P/N 469212 - same as used in that physical location on 55 and 56 400.
Check with you favorite vendor. IIRC, Chirco had these reproed some years ago; I have no experience with quality, but they are (were) pricey. Mike Dulinski might have a serviceable used one.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=129776