Re: rod and main bearing x-fit

Posted by Eric Boyle On 2008/8/4 12:53:22
Quote:
I don't know about the thrust insert for rod use. If u have a mill or a lathe is it feasable to cut the thrust flange from the thrust insert and use it??? Depends on price difference of the bearings wheather or not to be bothered with it.


99% of the time the thrust bearing is wider than the rest of the bearings. No matter what you do, you'll have to buy two sets of main bearings like Jack says.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=10585