Re: Ignition switch bezel

Posted by BH On 2008/8/25 7:42:32

OK, I see now that the add-on brass tangs are what replaces the broken ears, and the spring wire is used to retain the sleeve. Brilliant! (As the Guiness boys would say.)

However, could you use a slightly longer sleeve, and then notch back some of the copper to create tabs that could be folded over, rather than soldering brass onto the sleeve? I'm thinking if you could punch these out easily enough, you could sell them as a kit.

As scarce and expensive as original bezels are, I bet they'd sell well.