water pump

Posted by R H On 2014/6/22 13:33:05

what seal is this ,came out of nos box, had plastic impeller, yes ,,had,,,

also this shaft is shorter than mine, by about 3/16ths.,,should of shipped it ,off, what is 20 on end of shaft.

but ,,but ,,t&m, which its costing me for another impeller,,now,

but also want to use a stainless shaft,

breaking impellers, i know where i blew it, i wsa trying to save seal for ref.. if i would of cut it out i could of put a block under center of impeller,

what broke my cast, is that i used a hf, bearing separator, to try to get bearing off, well i bent one half, i didn;t see it, starting jacking pop,,,,,,

also that bearing is on there, even getting under the center with a block with 5/8 hole supporting the whole bearing it would not budge... that i will take to shop,,,,,

for the impeller, ,there is a foundary out here i can get the impeller cast in brass or alum..

Attach file:

---

  (55.10 KB)


  (58.00 KB)


  (74.45 KB)


  (68.81 KB)