for any new and up and comming ,, DIY ers,,,,,,,,
the 1/4 inch horse does not let pressure get to outside edge, all pressure is on center of impeller, need to cut out seal, which is a job,,dremel, does it,
if you didn't want shaft, you could it too,,
flaring tool work great for holding things to press out, i get a pipe inside dia. close to what i am pressing out,
also see henrys blog, 102,ish, he does excellent work,,
Attach file:
(76.21 KB) (95.02 KB) (82.81 KB) (83.04 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=145910