Need a distributor driven gear. Converting to Mopar electronics.
Posted by Jack Vines On 2014/9/16 15:09:13
FWIW, after some bad experiences with Pertronix, I'm converting some Packard V8 distributors to the old-but-reliable Mopar electronic modules.
The end result will cost more than a Pertronix, but I'm rebuilding the distributors also.
In going through one of the distributors, the drive gear hole and shaft were wallowed out egg-shaped. I've welded up the shaft hole and re-drilled it. However, whomever buggered it up originally also chipped a tooth on the driven gear.
Anyone have a junk distributor with a good driven gear?
jack vines
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=150040