Re: Camber adjustment on a 56, 400
Posted by Owen_Dyneto On 2014/10/1 11:42:59
This may help you visualize the adjustment, you're just rotating the pin up to a 1/2 turn; the eccentric (center) portion of the pin moves the top of the knuckle in or out. In this MOOG service part, the pin is rotated by removing one of the grease fittings which gives access to a recessed Allen head in the pin end. I don't recall which year/model this pin kit is for, but the principle is the same. One rubber grease seal not shown in the photo.
Attach file:
(28.49 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=150698