Re: Torsion Level Operational, or not?

Posted by Robert Freeman On 2015/2/16 11:33:49

I have found several wire breaks, all of them in the 'yellow' wires that goes thus: 'manual switch' to 'control-box terminal' to 'down limit switch'. As I mentioned, I SUCK at soldering, and I used Crimp connectors, which I need to check again. One other problem is that the TL wiring diagram states that the manual switch is "grounded through switch case". That may be an issue as well. My metal dash was re-painted way back when I had my interior done. The necessary ground may be hampered by the new paint (since I installed the manual switch after the interior was done).

All of this must be corrected b4 I can thoroughly check the actual mechanical movements of the TL system. Then I'll find out about the motor, pin and rod movement.

Thanks for all the hot tips, every one of them is a blessing