Re: Torsion Level Operational, or not?

Posted by Robert Freeman On 2015/3/9 19:35:54
Now that the beautiful sun has finally appeared I was able to remove the TL motor and found the drive pin intact and engaged to the worm gear. I am now kinda confused as to the TL's actions or rather in-actions. I did find that I was under the mistaken idea that there was a 'keeper washer' located on the worm gear shaft to hold it in-place. Apparently the motor shaft/pin on one end and the end cap along with some spacers hold the worm gear in-place. This was evident by the parts diagram and the ability to remove the worm gear once the motor was removed.

I must examine all switches and all wiring and repair or replace any questionable wires/connections or components. It's gonna take me some time to get through this one

Attach file:



jpg  (94.92 KB)
2993_54fe3c4f09b6c.jpg 783X1138 px

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=158762