Re: band shafts

Posted by R H On 2015/9/7 15:41:05

chrome moly another option, but they don't have it in 3/8s,

going with the g8 bolt, if, Packard would of used the shaft for low,brake, think they would be ok, its, 1/2 inch, the reverse is 3/8s, then you have that groove, not enough room in case to ream out to 1/2 inch/

spacers to center lever, see what I have around here ,,hot roll should be ok, might have 3/4 stainless, to get fancy, could put needle thrust washers on the sides,,,,