Re: 1955 Packard transmission PNDLR
Posted by HH56 On 2015/12/23 23:06:41
If you are still considering the project to replace the indicator plastic, here are some reference photos of the rear side of bezel showing all the screw locations.
To remove the bezel from the dash requires removal of the blower switch(es), both vent lever control assys (2 screws each recessed deep down inside the lever supports) and then two more screws on either side of the steering column. I can't remember but after removing the plate holding the rubber cover over the bottom of column, you may also have to remove the clamp holding the column to the dash brace to access those two screws on either side of column.
Attach file:
(81.82 KB)
To remove the bezel from the dash requires removal of the blower switch(es), both vent lever control assys (2 screws each recessed deep down inside the lever supports) and then two more screws on either side of the steering column. I can't remember but after removing the plate holding the rubber cover over the bottom of column, you may also have to remove the clamp holding the column to the dash brace to access those two screws on either side of column.
Attach file:
(81.82 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=170119