Re: Ultramatic trans cooler line routing
Posted by HH56 On 2016/4/14 13:18:03
It is somewhat hard to get photos of them after installation in car so here are a couple of shots of the tubes on an old engine -- no extra charge for the close up view of a mud dauber nest.
There is a double clamp at the bellhousing and another which uses a rear bolt at the motor mount. Not sure of your status with engine but with all the obstructions, it is extremely difficult to get the lines in once the engine is mounted in the car. It has to be done from under the car and you may have to disconnect the exhaust pipe. With the line length, unless you want to bend, position and then rebend once they are sort of in position the car needs to be fairly high.
Attach file:
(104.59 KB)
(122.14 KB)
(109.86 KB)
There is a double clamp at the bellhousing and another which uses a rear bolt at the motor mount. Not sure of your status with engine but with all the obstructions, it is extremely difficult to get the lines in once the engine is mounted in the car. It has to be done from under the car and you may have to disconnect the exhaust pipe. With the line length, unless you want to bend, position and then rebend once they are sort of in position the car needs to be fairly high.
Attach file:
(104.59 KB)
(122.14 KB)
(109.86 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=175272