Re: 700R4 gearshift linkage
Posted by HH56 On 2016/5/19 9:19:10
There are some photos of Scott's (poster "smith") Bendtsen installation. A couple show portions of the linkage so perhaps you can see enough to get some ideas.
https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=95724#forumpost95724 From what I can see they welded a bracket to the frame for one side support and made a bellcrank like link out of round rod and flat steel to adapt the GM trans connection to a lever attached to a modified or maybe shortened Packard side rod.
Not sure how similar the 4L60E transmission might be but IIRC, on KevinAZ's conversion there was also a photo showing a bit of linkage.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=176978