Re: 1956 Clipper Power Seats

Posted by Packard Don On 2016/5/29 18:08:26

I found the photos and see that the sleeves are definately there on my actuators but should be removable if necessary even if they are crimped on. One of the leadscrews is rusty so will need polishing and possibly oversize balls but that's all part of what I did when I was in the trade so shouldn't be a problem as long as it's not too pitted. If it is pitted, then I'll have to replace it. Likely it was made by Saginaw but there are several manufacturers making them to the same specifications Sid an original proves difficult to locate, I'll make a new screw.

On the seat, is it possible that the difference is only in the slides and not in the main seat frame itself?