Re: Advice on removing engine?

Posted by HH56 On 2017/10/10 18:24:22

You could make something for the oil pump but some of us have also used an inexpensive hand transfer pump from Harbor Freight to pump a volume of oil into the system before startup. You could buy a couple of fittings and use the ports on the ends of the heads or possibly even the larger port where the sender is located or the one at an angle below it to pump in two or three quarts and flood the passages. Obviously not as high a pressure as the regular pump but it will put out a surprising amount which does a decent job of filling the engine oiling system depending on how hard you push the handle.

Attach file:

---

  (33.08 KB)