Re: Repairing '55 Clipper seat panels

Posted by sanddoc On 2017/7/6 19:26:21

Gentlemen

I to have run into the problem with the older plastics breaking.
Interesting not on my 56 Packard, but on my 62 Ford and my 74
Dart swinger.
I thought I had the answer to all of these problems by using
the (3d printing) but even though I live in Los Angeles, I can't seem
to find such a business that is not flakey , I did just find out that
Office depot does 3d printing.
what is needed is the scanning, scan the parts then have them either
made with 3d or have a mold made...
On my 62 there are to many angles to try and fiber glass it, I tried, I tried
super bonding clue, nothing would hold the plastic.
But I think the 3d might be the way to go...
Anyone have any thought on this.
Best