wiring harness

Posted by flopperwatcher On 2017/11/7 23:41:19
I am placing a new wiring harness in my 39 120 conv. coupe and not being the person that removed the old one ,I am not sure where to correctly run it after it leaves the engine bay. There is a hole in the body [ drivers side ] that appears to be an exit for the loom . From that point back ,does the harness follow along the frame to the rear of the car or go into the passenger compartment towards the trunk? Thank you for any insight.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=197311