Re: Torsion level dash switch

Posted by Craig the Clipper Man On 2017/11/22 13:23:43

A couple of things to remember about the Torsion-Level:

1. If you are going to change a rear tire or your car is going up on a rack, be sure to turn off the T-L.

2. When you will inevitably have your car towed on a flatbed, before your car is raised, sit on the bumper to engage the T-L. When it goes back up, get off and turn off the T-L. The back end will be higher than it should be, but this will enable the car to move up onto the tow truck bed without scraping the exhaust pipes and/or bumper.

Packards/Clippers of these years tend to ride a bit lower in the back, so all of you know what I am talking about!