Re: stainless window trim

Posted by HH56 On 2018/3/25 11:24:48

Am assuming Steele Rubber? I had issues with the same thing on a windshield many years ago because I think the rubber Steele uses is softer than the original. IMO the rubber is a bit too flexible so the molding flanges are not gripped tight enough by the rubber grooves and keeps popping out.

I managed with some dabs of weatherstrip cement in the grooves and kind of twisting the molding as best I could to get it to conform so there was the least stress at the top of curves where mine wanted to pop out. Held the molding with masking tape to keep it more or less in the grooves until cement dried but it was a struggle.