Posted by Clipper55super On 2019/5/11 15:25:13

I'm attempting to fire the engine for the first time. I am not getting spark. I checked by pulling a plug and an in-line plug tester. I checked the coil which is new and has 1.4 ohms from terminal to terminal and 8600 ohms from positive to coil output wire. I have never adjusted point and believe I have it accurate at .016. (Could use help with confirmation on how to set them,as I used a YouTube video). I have new plugs, wires, rotor, and points, was sent the wrong cap so using the previous cap. What else could the issue be?

Thank you in advance for any assistance anyone can offer.

Shane