Gents,
I am at the point of trying to reinstall the front stab bar with new bushings from Max/Steele. I've read as many posts as I can regarding creating a version of the official tool and directions from Heinmuller/Ross.
I think I am going to try the Heinmuller/Ross approach which is to use vise grips to squeeze the bar in as far as possible, then a C-clamp horizontally to compress the clip while using a small screwdriver to lift the top tabs over the top of the lower control arm and into the slots.
Just to be sure I am chosing the proper pain, what is the right orientation of the end bushings? They are rectangular. So do I put the narrow end in the channel and really, really compress the clip with the C-clamp? Or do I force the wider end into the channel so that less is sticking out to be compressed by the C-clamp?
thanks
Bob
Attach file:
(246.66 KB) (290.07 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=219477